Inspecting Unvented Combustion Appliances
by Nick Gromicko and Ben Gromicko
For aesthetic reasons, builders will sometimes install a ventless gas, propane, or ethanol-burning fireplace in the home. These ventless appliances have real flames, providing the ambiance of a traditional fireplace, with convenience and cost savings for the builder because no chimney needs to be installed.
Manufacturers report that they burn at nearly 100% efficiency, releasing fewer harmful gases into the home than other types of fireplaces. However, because they are ventless, any unburned combustion byproducts are released directly into the living space because there is no chimney to vent them out of the home. Also, because no air intake is installed, many manufacturers recommend that homeowners open a window during operation of the fireplace, although there is no way to guarantee that they will follow this advice.
It is recommended that unvented combustion appliances should not be installed within the conditioned space of the home. Unvented combustion appliances include unvented fireplaces, also known as ventless, vent-free, or ductless fireplaces. These gas, propane, or ethanol-burning fireplaces have no vent, so they draw combustion air from the room they are in and release toxic combustion byproducts and moisture vapor back into the space in which they are located. Their use is banned in many states and municipalities.
In addition to possible combustion byproducts, ventless combustion appliances also release significant amounts of water vapor into the air. These products produce 1 gallon of water vapor for every 100,000 BTU, so a 30,000-BTU appliance would release nearly 1 gallon of water vapor for every three hours of operation, significantly adding to indoor humidity levels.
Due to safety, health, and moisture concerns, some building scientists recommend that unvented appliances never be installed in homes. ENERGY STAR Version 3.0 permits their installation but requires that an inspector test the appliance using a portable CO monitoring device and verify that the ambient CO level does not exceed 35 parts per million (ppm). The inspector should also confirm that the room size provides a minimum volume of combustion air for safe operation of the size of the appliance installed, as specified by the manufacturer and/or code. The National Fuel Gas Code prohibits the installation of ventless combustion heaters in bathrooms or bedrooms.
A ventless fireplace that is burning efficiently will have a primarily blue flame. Defects, such as plugged burner ports, a cracked burner, excessive gas input, impurities in the gas, or a gas leak somewhere in the unit, can impact performance, reducing the efficiency of the burn and increasing the amount of combustion byproducts released.
Some ventless fireplaces come equipped by the manufacturer with an oxygen-detection sensor that will automatically shut down the appliance if oxygen levels in the room become too low. InterNACHI recommends that the homeowner install a CO detector in the room near the ventless fireplace and in the same room. Because of safety concerns, several states and municipalities have banned the use of ventless combustion appliances.
How to check unvented combustion appliances:
A ventless combustion fireplace has no chimney. It draws combustion air from and releases combustion byproducts to the room in which it is located.
An inspector uses a portable CO monitor is used to test for ambient CO near a ventless combustion fireplace.
Can the health hazards of an unvented heater be reduced?
The most effective method to reduce the hazards is to discontinue use of the unvented combustion appliance by switching to vented-gas or electric appliances.
Where the use of unvented gas appliances is permitted, the following are suggested:
Ventilated fireplaces typically burn natural gas or propane and use a vent to bring outside combustion air directly into the firebox to support the fire. These fireplaces have tight-fitting glass doors across their face to prevent conditioned room air from being used as combustion air and then being expelled through the exhaust. Heat still radiates into the room. Consuming room air for combustion may deplete oxygen levels in the home. Exhaust gases can be expelled vertically up a chimney, or horizontally out a side wall. In addition to saving space and materials, eliminating the need for a traditional chimney provides tremendous flexibility in where these fireplaces can be located. These closed-combustion systems are much less likely to experience backdrafting, the hazardous situation in which exhaust gases are drawn into the home instead of being expelled to the outdoors, or contribute to backdrafting in other combustion appliances, such as water heaters and furnaces.
Unvented combustion appliances should not be installed within the conditioned space of a home. Their use is banned in many states and municipalities. Ventilated fireplaces help ensure that dangerous byproducts from burning fossil fuel cannot back-draft into homes.
We just sent you an email. Please click the link in the email to confirm your subscription!
OKSubscriptions powered by Strikingly